14EH Series 1/2 HP models are Little Giant Eliminator submersible high head effluent pumps designed to handle liquids with 3/4 inch solids. The 14EH-CIM is a manual 115V pump with a 20 foot power cord, a 2 inch FNPT discharge, and a shutoff head of 50 feet, and it's listed at 60 GPM. Its housing, volute, and impeller are cast iron with a protective epoxy coating for corrosion and rust resistance, and it has an oil filled motor housing and thermal overload protection. Contractors use effluent pumps like these to move effluent where the discharge must travel against significant head. Matching horsepower, head, and solids size to the application is what keeps a pump running reliably, so the specs on each model matter before the order goes in.
Subcategories
Buying Guide
Start with head and flow. The 14EH-CIM is listed at 60 GPM with a shutoff head of 50 feet, so compare those figures to the lift and pipe run on the job before picking a model. Shutoff head is the limit of what the pump can push against, so the working head needs to fall short of it. Water chemistry varies by site, so check the local supply first.
Next, confirm solids size. The 14EH-CIM is designed to handle liquids with 3/4 inch solids, so the application should not pass anything larger. When choosing among 14EH Series 1/2 HP pumps, check what the system actually carries.
Then check the electrical and discharge details. The 14EH-CIM runs on 115V, has a 2 inch FNPT discharge, and comes with a 20 foot power cord. Confirm the circuit, discharge piping, and cord reach before ordering. The pump has thermal overload protection, which is no substitute for a correctly sized circuit. It's a manual type, so decide how the pump will be controlled as part of the plan.
Finally, consider the environment. The housing, volute, and impeller are cast iron with a protective epoxy coating, and the hardware includes stainless steel screws, bolts, and handle. Little Giant lists a maximum operating temperature of 140°F, so confirm the liquid stays within it. Verify every spec against the product page before ordering.
Frequently Asked Questions
What solids can a 14EH Series 1/2 HP pump handle?
The Eliminator high head effluent pumps in the 14EH Series 1/2 HP family are designed to handle liquids with 3/4 inch solids. The 14EH-CIM lists a solids size of 3/4 inch. Confirm that figure against the application before ordering.
What's the shutoff head on the 14EH-CIM?
The 14EH-CIM, a 14EH Series 1/2 HP effluent pump, lists a shutoff head of 50 feet and a flow of 60 GPM. Shutoff head is the limit of what the pump can push against. Size the job's working head to fall short of it.
What voltage and cord length does the 14EH-CIM use?
The 14EH-CIM runs on 115V and comes with a 20 foot power cord. It has a 1/2 HP motor. Confirm the circuit before installing any 14EH Series 1/2 HP pump.
Is the 14EH-CIM a manual or automatic pump?
The 14EH-CIM is listed as a manual submersible high head effluent pump. Plan the control method as part of the installation. Check each 14EH Series 1/2 HP model's listing for its type.
What's the discharge size and housing material on the 14EH-CIM?
The 14EH-CIM has a 2 inch FNPT discharge. Its housing, volute, and impeller are cast iron with a protective epoxy coating. Verify the discharge size against the piping before ordering this 14EH Series 1/2 HP pump.