Duct Saddles makes a strapping accessory system built specifically for flexible HVAC ductwork. The company does not manufacture duct itself. It focuses on the hardware that supports and shapes flex duct where it's hung. This addresses the sagging and kinking that standard strapping alone tends to cause over a run. The core DS3 product installs directly onto strapping that's already in place, positioning it as a retrofit fix as much as a new-install component.
Product Lines
The DS3 duct saddle is a concave hanger that clips onto existing strap material. It spreads contact across the duct surface instead of letting strapping cut into it at a single narrow point. Duct Saddles has also introduced the DS3 Strapping & Tape Dispenser, a patent-pending tool built to speed up strap installation and cut down on wasted material during the job.
Why Contractors Specify Duct Saddles
Restricted or kinked flex duct chokes airflow. It forces the blower and compressor to work harder than the system was designed for, which shows up later as comfort complaints or premature equipment wear. The DS3 saddle installs on strapping that's already anchored at both ends. A technician can address a sagging run without cutting the strap loose and re-hanging it from scratch. The fix becomes a fast add-on for service calls where the diagnosis is a restricted duct rather than a failed component.
How to Choose Duct Saddles Products
Selecting a saddle comes down to matching it to the strapping already anchored on the job. The DS3 saddle is designed to clip onto existing strap material rather than replace it. Retrofit work on an existing sagging run is typically a faster fix than replacing the whole hanging system. New installs can incorporate saddles from the start to head off future sag. Pairing the saddle with the DS3 Strapping & Tape Dispenser can speed up the strapping step itself on jobs with multiple duct runs.
Frequently Asked Questions
What does the DS3 duct saddle attach to?
The DS3 saddle clips onto strapping that's already anchored on both ends, so it can be added without cutting the strap loose.
Is the DS3 saddle meant for new installs or retrofits?
Duct Saddles markets the DS3 for both; it works as a retrofit fix on sagging existing runs and as a preventive add-on during new installs.
What problem does restricted or kinked flex duct cause?
Restricted duct chokes airflow and forces the blower and compressor to work harder, which can show up as comfort complaints or added strain on the equipment.
What is the DS3 Strapping & Tape Dispenser?
It's a patent-pending tool from Duct Saddles built to speed up strap installation and reduce material waste on the job.
Does installing a DS3 saddle require removing the existing strap?
No, the saddle is designed to install onto strapping that's already in place at both ends.