Watts 800M4QT anti-siphon pressure vacuum breakers stop contaminated water from being pulled back into a potable water supply through backsiphonage, a risk in continuous-pressure systems like irrigation lines and industrial process water setups. The assembly uses a bronze body, a silicone rubber check valve disc, a plastic check valve seat, and stainless steel springs, with a lightweight plastic disc float that lifts to admit air and break a vacuum condition. Watts rates the 800M4QT for a maximum working pressure of 150 psi and a minimum of 15 psi, with an operating temperature range of 33 to 140 degrees Fahrenheit. It is intended for installation where the protected equipment carries a health hazard risk and where water enters at or below the equipment's flood rim, the exact scenario that creates a backsiphonage risk in the first place. Because the assembly has to sit above the highest downstream outlet to function correctly, mounting height matters as much as pipe size when planning the installation.
Subcategories
Buying Guide
Sizing the Watts 800M4QT anti-siphon pressure vacuum breaker to the existing pipe run comes first, since an undersized assembly restricts flow and an oversized one adds unnecessary cost without a performance benefit. The 800M4QT is available across the common sizes used in irrigation and industrial process water lines, so matching pipe diameter is usually straightforward.
Mounting height needs attention during installation planning rather than being an afterthought. The assembly has to sit above the highest downstream outlet to function correctly, since its air inlet valve depends on that elevation to break a vacuum condition properly.
Connection style is worth deciding early if the installation may need frequent removal for winterization or service. A quick-connect model saves time on a system that gets serviced or drained every season, while a standard threaded connection suits a more permanent installation.
Freeze exposure should factor into the decision for any outdoor or unheated installation. A SentryPlus Alert-compatible model adds a monitoring layer on top of standard winterization test cocks, which is a reasonable addition for irrigation systems left outdoors through cold weather.
Maintenance planning rounds out the decision. Keeping a repair kit matched to the installed size and configuration on hand means a worn check valve disc or spring can be replaced without pulling the entire bronze body out of the line.
Frequently Asked Questions
What does a Watts 800M4QT vacuum breaker protect against?
It prevents backsiphonage, which is contaminated water being pulled back into a potable water supply, in continuous-pressure applications like irrigation and industrial process water systems.
What is the pressure rating of the Watts 800M4QT?
Watts rates the 800M4QT for a maximum working pressure of 150 psi and a minimum of 15 psi.
How high above the system does the 800M4QT need to be installed?
It needs to sit above the highest downstream outlet, since its air inlet valve depends on that elevation to properly break a vacuum condition.
Can a worn Watts 800M4QT be repaired instead of replaced?
Yes, repair kits are available to rebuild the internal wearing components, such as the check valve disc and springs, when the bronze body itself is still in good condition.
What is the SentryPlus Alert feature on some 800M4QT models?
It is an integrated freeze sensor that flags low-temperature conditions that could freeze and damage the assembly, useful for outdoor or unheated installations.