750 Mv Generator For Use With PG9 Style Pilot Burners, 48" Cable,(F Spade Clip)

My gas fireplace insert is 30 years old and has been wonderfully reliable. But ceases to light the main burner every 5 to 7 years, so I replace the millivolt generator which I have always ordered from SupplyHouse,com. They've always been there and able to furnish the same unit for me!

Easy to install, no adjustment required , Hope this one last longer than 3 years

This works perfectly with my William Wall Furnace to keep the pilot light on. Thanks a lot!

Same manufacturer and model as the original in gas insert. Relative to the original, an additional 1/16" is exposed to the pilot flame. The unit comes with two fork connectors. I replaced one of those with a female spade connector for my application. Easy to do with a soldering iron. The original took a couple of minutes to acheive ~385 mv; the new one takes less than a minute to acheive ~525 mv. My pilot light was constantly going out; it now stays lit. My actual flame took a few seconds to come up; it comes right up now. Seems to have taken care of my issues.

Installed part in my wall heater and it worked for less than a week. It degraded to the point that it only generated 470 milli volts which was enough operate the pilot but not the heater manifold.

I spent months trying to get a replacement Thermopile for my Duo-Therm furnace. I was told nothing was available and would need to replace the furnace.

This part was an exact replacement,to the original,in our furnace. Ordered it from Supply House. Received it ahead of projected shipping date.Problem cured.

In my application, the old unit could just be wiggled and pulled out of the bracket that holds both the pilot nozzle and the thermocouple; no unbolting or unscrewing. Then the new unit may pushed into place.

Hard to find part arrived very quickly to get the heat back on!