3/4" Home Run Manifold w/ 1/2" Sharkbite Outlets (12 Outlets)

I needed this item to make a change over in the water line service to my bathroom project. This included two shower installations, The vanity hook up in two bathrooms plus the two toilets.

Had a problem with a product and they jumped on it. It was resolved in 48 hours. I will use them as a preferred vendor. The manifold is also good...

This manifold was super easy to put together and worked great for running new pex lines through my house. No problem with leaks or broken materials just read the instructions amd good to go.

My house was built back in the mid-late 80's when the latest trend was Polybutene piping. As everyone now knows, it is no longer acceptable by US building codes. After my first major leak, being old school, I replaced all the polybutene piping in the basement with copper, but left the second-floor piping in place. It was going to be a lot of work to replumb using copper (lots of joins, cutting open walls, ceiling, etc.) Well, time has a way of slipping by and before I knew it, I had a leak in the polybutene piping on the second floor. This time I decided to use pex, but wanted to minimize the number of connections to eliminate potential leaks in the future. The best solution was to use a home run manifold and run each line to the bathroom fixtures. I have use Sharkbite products over the years and really love them, and although some users seem to have had problems with this product, I settled on the Sharkbite ¾" Home Run Manifold w/ ½" Sharkbite Outlets(12). Installation was very straight forward, and no problems with hooking it up. It worked as expected, not one leak.

i have tried everything i know to try to get this thing to stop leaking. its leaking at both inlet valves and every outlet fitting. im at my wits end cuz i ripped out all my old plumbing to install this and if it didnt leak it would be an awesome product....ive bought plenty of sharkbite fittings in the past and ive never had an issue...this part was way to expensive to not work...im very disappointed

I used this manifold to replace my 70 year old pipes, just mounted it under the house and attached the main cold and hot runs. After that, I worked through all the individual connections to the shower, sinks, and toilets. With a valve at each point, it allowed the house to have partial water service as a went through the entire replacement process. It allowed me to take my time, which is a big plus for a DIY project.

I chose this manifold for the individual 1/4 turn valves and push to fit connections.Everything went together easily with no problems.

Works great, a little trouble getting cold supply line to not leak. Would suggest product coming with sharkbite fittings for supply side also.

Worked very well for my basement finishing project.

Re-piping my home and purchased this item to isolate different areas of the home. Was able to re pipe over several weekends by using this manifold.