Fasco Accessories are the mounting hardware, capacitor kits, and installation components that keep Fasco draft inducer and blower motors running once they're set into a furnace or water heater. The lineup includes capacitor mounting kits, such as the KIT6001, which pairs a rubber boot with a mounting bracket, and lug band kits like the NO55L 5-1/2 inch large lug band that secures a motor without drilled mounting feet. A tech pulling a failed inducer motor often needs one of these accessories to finish the swap, because OEM furnace brackets and replacement Fasco motor housings don't always line up without an adapter kit. Stocking the correct bracket, harness, or capacitor kit alongside a replacement motor cuts down on return trips mid job. Fasco Accessories matter most on service calls where the original motor is discontinued and a universal replacement needs extra hardware to fit an existing furnace cabinet.
Subcategories
Buying Guide
Start with the failure, not the catalog. A dead capacitor calls for a capacitor mounting kit; a motor that won't seat on the old furnace bracket calls for a mounting bracket or lug band kit; a burned connector calls for a wire harness. Confirm the exact Fasco motor model number before ordering an accessory, since bracket bolt patterns, lug band diameters, and harness connector styles are matched to specific motor frames rather than sold as universal fits. Fasco Accessories are organized by function on the category page, so filtering by accessory type narrows the list faster than browsing by motor series. Pull the old part off the failed motor and compare it side by side with the listing photo when a part number isn't visible on the old hardware, since decades of running units can wear off stamped labels. Order the capacitor kit and the replacement capacitor together when a bracket has failed, since a corroded rubber boot usually means the capacitor underneath has been exposed to the same heat and moisture. Carrying a few lug bands and harness connectors on the truck for older units helps, since these accessories cross reference across several motor families and get used often on legacy furnace and water heater service calls. Checking motor frame size and voltage before ordering avoids a mismatched accessory holding up a repair.
Frequently Asked Questions
What Fasco accessory do I need to replace a bad run capacitor on an inducer motor?
A capacitor mounting kit, such as the Fasco KIT6001, pairs a rubber boot with a bracket to hold the replacement capacitor in place near the inducer or blower motor. Matching the kit to the motor frame keeps the capacitor cushioned and its terminals protected from moisture. Ordering the kit alongside a new capacitor avoids a second call for a missing bracket.
How does a lug band mounting kit differ from a bolted motor bracket?
A lug band mounting kit, like the Fasco NO55L 5-1/2 inch large lug band, wraps around the motor housing and clamps down with a band instead of using bolted feet. Motors without drilled mounting feet rely on this style to stay secure inside the furnace or air handler cabinet. Band size has to match the motor's housing diameter for a tight, vibration free fit.
Why won't a replacement Fasco motor bolt straight onto an old furnace bracket?
Bolt patterns and frame sizes vary across Fasco motor families, so a universal replacement motor sometimes needs an adapter bracket to line up with the existing furnace or water heater mounting holes. Checking the old motor's frame size and hole spacing before ordering narrows down which bracket accessory fits. Skipping this step usually means a second parts run mid repair.
Do Fasco wire harnesses fit any replacement motor?
Wire harnesses and lead kits are matched by connector style and length to specific motor and control board combinations, not sold as one size fits all. A harness that doesn't match the original connector style forces a wire splice, which can compromise the factory weather seal. Confirming connector type before ordering keeps the swap clean.
When should a rubber boot on a capacitor mount be replaced along with the bracket?
A cracked or hardened rubber boot usually signals that the capacitor underneath has been exposed to the same heat and moisture that damaged the bracket. Replacing the boot and bracket together as a kit, such as the KIT6001, protects the new capacitor from the same failure. Skipping the boot replacement risks a repeat capacitor failure soon after the repair.