
| Amperage: | 6 |
|---|---|
| Application: | Heat Only |
| Stages: | 1 Heat |
| Programmability: | Non-Programmable |
| User Interface: | Mechanical |
| Mount: | Round |
| Power Method: | System Heating Controls |
| Changeover: | Manual |
| Temperature Range (F): | 40°F - 90°F |
| Max Temp Differential: | 1°F |
| Operating Humidity: | 5 to 90% RH, non-condensing |
| Voltage: | Low voltage 24V |
| Wattage: | 0.4 to 180 |
| Wiring: | R W |
| Frequency: | 60 Hz |
| Color: | Premier White |
| Height: | 3-11/16" |
| Width: | 3-11/16" |
| Depth (Inches): | 1-7/16" |
Please refer to page 4 of the owner's manual for more information on using the backlit display. http://s3.pexsupply.com/manuals/1295372427495/44277_PROD_FILE.pdf
Note: the backlight works only when one turns the control ring and the light then shuts off in about five seconds. If your unit is not working like this than your thermo before was not working all the time either. Perhaps a short in the wiring triggered by someone walking over the wire area or slamming a door.
Light is only supposed to come on when you push the light button or make a tempature change. It stays on for around 20 seconds and then goes out. Sounds like yours is working correct to me.
Yes it can be. As long as you only need a thermostat to control heat and not air conditioning, this will work for you.