NY traps are cast iron drainage fittings that combine a trap and a cleanout access point in a single body, built to the pattern long used in dense urban plumbing systems where floor space around a drain line is tight. The design routes wastewater through a water seal that blocks sewer gas from entering a building while giving a plumber a bolted or threaded access point to clear a stoppage without cutting into the line. Cast iron construction stands up to the weight of concrete slabs poured around a below-grade drain and resists the corrosion that PVC alternatives can struggle with in older commercial buildings. Plumbers reach for NY traps most often on renovation or repair jobs in older multi-family and commercial properties where the original drainage layout used cast iron throughout, since matching material at a trap replacement keeps the whole run compatible. Choosing the right size and configuration up front avoids a second trip once a slab or wall has already been opened up.
Subcategories
Buying Guide
Sizing an NY trap correctly starts with matching the existing drain line diameter, since these fittings connect directly into cast iron drainage runs and an undersized or oversized trap won't seal properly at either end. Check whether the application calls for a standard or deep seal design before ordering, since local plumbing code often dictates the seal depth for specific fixture types like floor drains in spaces that go unused for stretches at a time. NY Traps come in cast iron as the standard material, which holds up under the weight of a poured slab and resists the corrosion that can affect other materials in older buildings, so sticking with cast iron on a renovation project keeps the repair consistent with the rest of the drainage system. Confirm the cleanout access orientation fits the available floor or wall space before ordering, since these traps are often installed in tight mechanical rooms or under fixtures where clearance is limited. Renovation and repair work in older multi-family or commercial buildings accounts for most of the demand for this fitting, since new construction more often specifies PVC or ABS drainage systems instead of cast iron. Ordering the cleanout cover and any gaskets at the same time as the trap body avoids a return trip once the old fitting has already been removed and the replacement needs to go in the same day.
Frequently Asked Questions
What's the difference between a standard and deep seal NY trap?
A deep seal trap holds a taller column of water, which resists drying out on drains that sit unused for long stretches. Standard seal traps work fine on fixtures that see regular daily use. Local plumbing code sometimes requires deep seal traps on specific fixture types like floor drains in mechanical rooms.
Can a cast iron NY trap be replaced with PVC?
It depends on local code and how the rest of the drainage run is built, since mixing materials at a transition point needs the correct fitting and often a code-approved adapter. Many older buildings keep cast iron throughout a run for consistency and long-term durability under a slab. Checking with the local inspector before substituting materials avoids a failed inspection.
How often does the cleanout cover on an NY trap need replacing?
There's no fixed schedule, but a cover that's cracked, no longer seals gas, or has stripped threads should get replaced right away. Covers in high foot-traffic areas wear faster than those tucked into a mechanical room. Keeping a spare gasket on hand speeds up the swap.
Why do older buildings use NY traps instead of a simpler P-trap?
The combined trap-and-cleanout design saves space and gives access to clear a stoppage without cutting into the cast iron line, which mattered in buildings where drain runs were set in concrete decades ago. A separate P-trap and cleanout would take up more room and cost more to install in that kind of construction. The design has stuck around because it still solves that same space problem in renovation work today.
What causes an NY trap to lose its water seal?
Extended periods without use let the water in the trap evaporate, which is the most common cause on floor drains in seasonal or low-traffic spaces. A cracked trap body or failed gasket can also let the seal drain out faster than it should. Running water through the fixture periodically or upgrading to a deep seal design addresses most cases.