Watts 0006960 1/2"-1" Repair Kit is a factory repair kit for designated Watts water pressure reducing valves, used to restore proper internal operation on selected 1/2 inch through 1 inch N45B and related valve models without replacing the complete body.
Key Features:
- OEM Watts repair kit for 1/2" through 1" pressure reducing valves in the specified series
- Includes replacement diaphragm and internal assembly components required for standard service
- Designed to restore outlet pressure control performance in an existing valve body
- Kit parts supplied as a matched set to fit the targeted Watts valve models
Compatibility & Applications:
- Intended for use on compatible Watts N45B, LFN45B, or related 1/2" to 1" pressure reducing valves as specified by Watts documentation
- Used in residential and commercial potable water systems where these valves are installed on domestic water lines
- Suitable when the valve body remains in good condition and only the internal regulating components require service or replacement
Installation & Operation Notes:
- Shut off water supply and relieve downstream pressure before servicing the valve
- Follow the specific Watts service instructions for the installed valve model when disassembling the body
- Remove the existing internal assembly, diaphragm, and related parts, then install the new components from the kit in the same orientation
- After reassembly, slowly restore water supply, check for leaks, and adjust outlet pressure within the valve's rated range as needed
Maintenance & Troubleshooting:
- Use the repair kit when outlet pressure drifts out of range, when the valve fails to regulate properly, or when internal wear is observed during inspection
- Periodically check the system for debris that could affect valve performance and clean strainers or upstream protection devices as required
- If pressure problems continue after installation, verify that the inlet pressure is within specification and that the valve is installed according to Watts guidelines