Flame Sensor LH680014

On my Bryant furnace the flame sensor has to be cleaned or replaced every 2-3 years. Easy to install as the screw hole is on the sensor tab is preset to match the hole on the furnace - another words there is only one way you can install it. Unplug the old wire and plug the new one on. I keep a spare on hand -- last time it went bad was on a Sunday.

Installed and working fine no problems.

I cleaned the surface of the old flame sensor the previous 2 years to prevent the furnace from shutting down shortly after start-up, but this year cleaning did not work. The new flame sensor fixed the problem.

Ordered on 11/14/16 and received item 11/15/16 standard shipping. Excellent service and price. The LH680014 Bryant Carrier furnace flame sensor is used on most Bryant, Carrier 80% furnaces. This flame sensor is used in over 2,600 Bryant Carrier models. The LH680014 replaces Bryant, Carrier flame sensors part numbers: LH33WZ515, LH33WZ511, LH680012 and LH33WZ517.

I used this on my own furnace. It works well. It arrives quickly. I will buy from Supply House again.

While I was replacing the ignitor in my Bryant 310 furnace, I figured I'd replace the flame sensor as well. After some research, I found this LH680014 flame sensor which replaces the original part LH33WZ517. It works great and was easy to switch out. The nice part is I didn't need the plug, and the plug on this sensor comes right off. Didn't need to rewire anything.

Fit right in and works perfectly.

Great price, exact fit.

The part was an exact replacement. This along with the ignitor saved time and,I suspect, a fair amount of parts and labor cost.

This is a must have as a backup for your furnace. It was easy to tell this was the part that was bad since the furnace would ignite and then shut off right away. With a hex screwdriver I was able to put in my back up and have the furnace running without an expensive service call.