1/2" Plastic Bend Support

Plastic isn't strong enough to make a 90 degree angle.

I had four of these break in a row! Thankfully, I had some Uponor ones on the van too. It has been cold here the last few days, highs about 40 and lows in the 20's. But 4 in a row? And then no problem with the name brand. The Uponor brand supports are tough to get in, but at least they don't break.

Bend the pex so much easier.

WORKS GREAT

WORKS GREAT

I cannot edit my last review where I said Everflow is better with picture. But after using both, I have experienced uponor is much better - Everflow tends to slip out again and again and uponor stays at it's place once installed. Uponor is more snug fitting. Pay extra and buy Uponor

Used on 3/4 hePEX. Pipe pops out of support. Two broke in half while trying to install pipe into bend support. These are junk stick to the uponor ones.

Everflow is bigger, better and cheaper. Please check my picture, I hope it will help others. From website, you can NOT tell the size difference nor they put measurements.

These are affordable ... They hold the pex to a pretty good 90 ... That is usually enough to fit in 2x4 stud wall ... The 3/4 ones are a little tougher to use ... I find after puting tube in bend putting a zip tie on either end fixes the problem of having the pipe come out

Great prices and great servive