ProPEX EP Plugs are engineered polymer fittings that permanently or temporarily terminate the end of Uponor PEX tubing. Uponor lists the plugs in six sizes, from 1/2" PEX (Q4350500) through 2" PEX (Q4352000), with a part number for each size. The plugs belong to the ProPEX EP line, which uses the ASTM F1960 expansion connection and serves hot and cold domestic potable water, residential fire sprinkler, and hydronic radiant heating and cooling systems. Installation requires a ProPEX tool, and ProPEX rings are sold separately, so a plug order should account for both. Capping open tubing ends cleanly lets a crew keep building the rest of the system without leaving loose ends exposed. Matching the plug to the tubing size and confirming the tool and rings before the job starts prevents delays on site and keeps every termination consistent from one run to the next.
Subcategories
Buying Guide
Start with the tubing size, because a ProPEX EP plug has to match the Uponor PEX tubing it terminates. Uponor lists plug sizes of 1/2", 3/4", 1", 1 1/4", 1 1/2", and 2" PEX, each with its own part number, so read the tubing label and pick the matching entry first.
Next, confirm the installation hardware. Uponor states that a ProPEX tool is required and that ProPEX rings are sold separately. A crew that already owns the tool still needs a ring for every plug, so add rings to the same order and avoid a second trip to the supplier.
Then decide whether the termination with ProPEX EP Plugs is permanent or temporary. Uponor describes the plugs as terminating the tubing end either way, so the choice comes down to the job plan. A stub that stays in the wall is a final termination, while a temporary cap should be noted so the next trade knows what to expect.
Finally, match the system type. ProPEX EP fittings serve hot and cold domestic potable water, residential fire sprinkler, and hydronic radiant heating and cooling systems, and the line uses the ASTM F1960 connection. Check that the other fittings on the job use the same connection standard so every termination and joint is consistent.
Frequently Asked Questions
What sizes do ProPEX EP plugs come in?
Uponor lists ProPEX EP Plugs in 1/2", 3/4", 1", 1 1/4", 1 1/2", and 2" PEX. The part numbers are Q4350500, Q4350750, Q4351000, Q4351250, Q4351500, and Q4352000. Pick the plug that matches the tubing size on the job.
Do I need a special tool to install a ProPEX EP plug?
Yes. Uponor states that a ProPEX tool is required for ProPEX EP plugs, and ProPEX rings are sold separately. Plan for the tool and the rings before heading to the job.
Can a ProPEX EP plug be used as a permanent cap?
Yes. Uponor describes ProPEX EP plugs as fittings that permanently or temporarily terminate the end of Uponor PEX tubing. The same plug can serve either role, so the job plan decides which one applies.
What are ProPEX EP plugs made of?
ProPEX EP Plugs are made of engineered polymer, and the EP in the name stands for that material. They belong to the Uponor engineered polymer fitting line that uses the ASTM F1960 connection.
What systems can ProPEX EP plugs go in?
ProPEX EP Plugs belong to a fitting line that Uponor lists for hot and cold domestic potable water, residential fire sprinkler, and hydronic radiant heating and cooling systems. Confirm the project spec and local code before choosing any fitting.