| Application: | Electric Heat (Line Voltage) |
|---|---|
| Stages: | 1 Heat |
| Programmability: | Non-Programmable |
| User Interface: | Push Button |
| Mount: | Vertical |
| Power Method: | Hardwired |
| Voltage: | 120v |
| Switch: | SPST |
| Hertz: | 60 |
| Color: | White |
| Height: | 4.9" |
| Width: | 2.8" |
| Depth (Inches): | 9/10" |
| Heating Cycles: | 15 Minutes |
if the 2 mats are within the Watts (120V): 2000W, Amps (120V): 16.7 then yes.
No, this unit controls heating only. Yes, this thermostat consists of a control module which must be mounted on a PB112 Series power base.
I don't see why not, as long as the pump is well within the rating of the thermostat. I assume you are looking at a small wet rotor pump such as the Taco 007,and if so should work fine.
Yes you can just make sure you don't turn up the heat as high as you would in the house cause you will be way to hot!
The listed replacement for your thermostat is part 1A65-641 which you can find here: http://www.pexsupply.com/White-Rodgers-1A65-641-Beige-Line-Voltage-Wall-Thermostat-SPST-Open-On-Rise-No-Thermometer-14346000-p
Please refer to page 2 of the following manual: http://s3.pexsupply.com/manuals/1264693965328/24839_PROD_FILE.pdf