Hap System, sold under the HAP Hangers name, is a pipe support product line manufactured by RectorSeal. RectorSeal is an HVAC and plumbing manufacturer headquartered in Houston, Texas, and owned by CSW Industrials. The line was built around combining pipe support and nail or screw protection into a single fastened component for plumbing installations.
RectorSeal backs the HAP Hangers line with a minimum three-year limited warranty and technical customer support. The line is positioned for plumbing contractors working on both indoor and outdoor CPVC, PEX, or copper piping systems.
Product Lines
HAP Hangers are available in sizes from 1/2 inch to 2 inch diameter for CPVC, PEX, and copper pipe, with a powder-coated steel construction built to resist corrosion. Each hanger has a snap-together design intended for quick vertical and horizontal installations without additional strapping or plates.
The stud guard portion of the hanger is rated to withstand impact from a nail gun using up to 100 PSI of pressure. The hangers are also designed to be reusable rather than single-use. This gives the line a combined support and protection function in one part.
Why Contractors Specify Hap
Plumbers specify HAP Hangers because the snap-together design replaces the separate metal strapping and nail plate steps of a traditional install with one part. This cuts installation to as little as 7 seconds per hanger versus up to 2 minutes with the older two-part method. That time savings compounds across a job with dozens or hundreds of pipe runs.
The rounded edges on the powder-coated steel body also reduce the risk of installer injury during handling compared to sharper traditional strapping. The reusable design lets a crew reposition a hanger during rough-in without needing a new part.
How to Choose Hap Products
Match the hanger size to the actual pipe diameter and material. HAP Hangers are sized specifically for CPVC, PEX, or copper in increments from 1/2 inch to 2 inch rather than a universal size. Confirm whether the installation location needs a standard surface-mounted hanger or a back-of-stud configuration before ordering.
For exterior or exposed installations, confirm that the corrosion resistance of the powder-coated finish meets the project's environmental exposure requirements. Also verify that the stud guard's 100 PSI nail gun rating is sufficient for the framing and finishing methods used on the job.
Frequently Asked Questions
Who manufactures HAP Hangers?
HAP Hangers are manufactured by RectorSeal, an HVAC and plumbing manufacturer based in Houston, Texas and owned by CSW Industrials.
What pipe materials do HAP Hangers support?
HAP Hangers are built for CPVC, PEX, or copper piping in sizes from 1/2 inch to 2 inch diameter.
How much faster is a HAP Hanger install compared to traditional strapping?
According to RectorSeal, installation takes as little as 7 seconds with a HAP Hanger versus up to 2 minutes using traditional metal strapping and a nail plate.
Can HAP Hangers be reused?
Yes, the hangers are designed to be reusable rather than single-use, so a crew can reposition one during rough-in without replacing it.
What warranty does RectorSeal offer on HAP Hangers?
RectorSeal backs the HAP Hangers line with a minimum three-year limited warranty along with technical customer support.