Master Flash is a roof pipe flashing line manufactured by Aztec Washer Company, headquartered in Poway, California. The brand focuses specifically on flashings that seal roof penetrations around pipes, vents, and other rooftop equipment.
Aztec Washer Company built the Master Flash line around a one-piece design intended to install in about five minutes. The approach aims to reduce the labor and precision typically required to flash an irregular roof penetration.
Product Lines
The Master Flash catalog is organized around the roofing application rather than a single universal part. Categories include metal roof flashings, residential flashings, solar installation flashings, HVAC-specific flashings, retrofit flashings for existing roofs, square pipe flashings, and custom options for non-standard penetrations.
Aztec Washer also manufactures Master Seal bonded washers in stainless steel, 316 stainless steel, galvanized steel, and aluminum. These washers are typically sold alongside the flashing line for fastening applications on the same roof.
Why Contractors Specify Master Flash
Roofing and HVAC contractors often reach for Master Flash when a penetration does not match a standard round pipe boot. The line's flexible base and material choice of EPDM rubber or high-temperature silicone let a single flashing accommodate a range of pipe and vent diameters and roof pitches. This cuts down on the number of SKUs a crew needs to stock for odd-sized penetrations.
The material choice also affects where a given flashing performs best over time. EPDM and silicone are both compounded for resistance to ozone and ultraviolet exposure. This matters for a component that stays outdoors and exposed to weather for the life of the roof.
How to Choose Master Flash Products
Selecting a Master Flash flashing starts with the roof type and the pipe or equipment diameter being sealed. Metal roof panels, tile or membrane roofs, and solar array penetrations each have a flashing category built for that surface. Using a residential flashing on a metal panel roof, or the reverse, can leave gaps at the base.
Material selection matters too. High-temperature silicone is the better choice for penetrations near exhaust vents or other heat sources, while EPDM rubber covers most standard vent and pipe penetrations. Confirming the pipe or vent outside diameter against the flashing's rated range before installation avoids a flashing that will not compress down to seal properly.
Frequently Asked Questions
Who manufactures Master Flash roof flashings?
Master Flash is manufactured by Aztec Washer Company, based in Poway, California.
What materials are Master Flash flashings made from?
The line uses EPDM rubber or high-temperature silicone, both compounded to resist ozone and ultraviolet exposure.
Is there a Master Flash option for solar installations?
Yes. Aztec Washer Company makes a dedicated solar applications category within the Master Flash line.
Does Master Flash work on metal roofs?
Yes. The Master Flash catalog includes a metal roof flashing category.
Does Aztec Washer Company make anything besides flashings?
Yes. The company also manufactures Master Seal bonded washers in stainless steel, 316 stainless steel, galvanized steel, and aluminum.