Rebates:
You may be eligible for rebates from your local utility company and state. Search your zip code in the link below for information about rebate programs that apply to you. Bradford White Rebate Center
Overview:
Like the TTW1®, the TTW2® model is also power vented but offers higher BTU/Hr. inputs, additional insulation and larger gallon capacities. The TTW2® also offers greater installation flexibility with the ability to vent through a wall or roof, with either 3 or 4 PVC, ABS or CPVC pipe.
Features:
- ENERGY STAR® Qualified - This model qualifies for the January 1st, 2009
minimum ENERGY STAR® EF requirement, as well as most utility rebate programs. (50 & 65 gallon models only)
- Advanced ScreenLok® Technology Flame Arrestor Design - Flame arrestor is
designed to prevent ignition of flammable vapor outside of the water heater. (50 & 65 gallon models only)
- Flammable Vapor Sensor - Electronic sensor prevents burner operation if
flammable vapors are detected. The sensor will also prevent operation if there is
ongoing flammable vapor burn inside the combustion chamber.
- Maintenance Free - No regular cleaning of air inlet openings or flame arrestor is
required under normal conditions.(50 & 65 gallon models only)
- Sight Window - Offers a view into the combustion chamber to observe the
operation
of the pilot and burner.(50 & 65 gallon models only)
- Powerful Blower Motor - Our significantly quiet design has greater resistance to
outside winds and the power to vent in many difficult venting situations.
- Factory Installed Hydrojet®2 Total Performance System - Cold water inlet
sediment reducing device helps prevent sediment build up in tank. Increases first
hour delivery of hot water while minimizing temperature build up at top of tank.
- Vitraglas® Lining - Bradford White tanks are lined with an exclusively engineered
enamel formula that provides superior tank protection from the highly corrosive
effects of hot water. This formula (Vitraglas®) is fused to the steel surface by firing at
a temperature of over 1600° F.
- Honeywell Self Diagnostic Electronic Gas Control - Intelligent gas control with
spark to pilot ignition system eliminates the constant burning pilot. This results in
savings of pilot gas during stand by periods (120 V.A.C.).
- Enhanced Performance - Proprietary algorithms provide enhanced First Hour
Delivery ratings and tighter temperature differentials.
- Advanced Temperature Control System - Microprocessor constantly monitors and
controls burner operation to maintain accurate and consistent water temperature
levels.
- Intelligent Diagnostics - An exclusive green LED light prompts the installer during
start-up and provides ten different diagnostic codes to assist in troubleshooting.
- Pilot On Indication - Flashing green LED provides positive indication that pilot is on.
- Horizontal and Vertical Venting - With 3" or 4" PVC, ABS or CPVC (Maximum
equivalent vent length on reverse side).
- 2" Non-CFC Foam Insulation - Covers the sides and top of tank to save energy by
retarding loss of heat. Also increases jacket rigidity.
- Water Connections - 3/4" NPT factory installed true dielectric fittings.
- Factory Installed Heat Traps - Design incorporates a flexible disk that reduces
heat loss in piping and eliminates the potential for noise generation.
- Protective Magnesium Anode Rod.
- 3/4" NPT Side Connections.
- Pedestal Base.
- T&P Relief Valve - Included.
- Brass Drain Valve - Durable tamper proof design.