Amtrol indirect water heaters are storage tanks that produce domestic hot water using heat drawn from a boiler loop rather than a dedicated burner or heating element. A coil or jacket inside the tank carries hot boiler water past the stored domestic water, transferring heat without the two ever mixing. Amtrol markets this line under its BoilerMate name, covering both residential and commercial applications where a boiler already serves space heating and can be tapped for hot water at the same time. Because there's no standalone combustion chamber to maintain, an indirect tank tends to need less service over its life than a fuel-fired water heater, which is a large part of why contractors spec them alongside a new or existing boiler installation.
Subcategories
Buying Guide
Confirm the boiler's output can support both space heating and domestic hot water recovery before sizing an indirect tank, since an undersized boiler will struggle to satisfy both loads during a cold snap. Amtrol indirect water heaters are only as fast to recover as the boiler feeding their coil, so matching tank volume to the home or building's peak draw, not just its average use, avoids a tank that runs out of hot water during back-to-back showers or a busy kitchen.
Tank construction is the next consideration. A glass-lined or stainless tank interior holds up better against the corrosion and scale that build up in stored domestic water over years of service, which matters more on an indirect tank than a tankless unit since the water sits between draws. Check what anode rod protection ships with the tank and plan to inspect or replace it on a normal maintenance schedule rather than waiting for a leak to surface.
Finally, plan the control side of the installation alongside the tank itself. An indirect water heater needs a priority control, commonly an aquastat, to tell the boiler when to shift output toward the tank's coil and when to release it back to space heating. Getting this sequencing wrong is a common source of comfort complaints, so confirm the boiler's control board supports the priority scheme the tank requires before the job is quoted, not after the tank is already piped in.
Frequently Asked Questions
What does 'indirect' mean for this style of water heater?
It means the tank has no burner or heating element of its own. Hot water from a boiler loop circulates through an internal coil or jacket, transferring heat to the stored domestic water without the two supplies mixing.
Can an Amtrol indirect tank run without a boiler?
No. Indirect water heaters depend entirely on an external heat source, almost always a hydronic boiler, so they only make sense in a home or building that already has one for space heating.
Why do indirect tanks often need less maintenance than fuel-fired water heaters?
There's no separate combustion chamber, burner, or flue to service since heat comes from the boiler loop. Maintenance mostly comes down to checking the tank lining and anode protection on a normal schedule.
How is tank size chosen for an indirect water heater?
Sizing should be based on peak simultaneous hot water demand, not average daily use, since an undersized tank recovers too slowly to keep up during high-draw periods like back-to-back showers.
What control does an indirect tank need to work with a boiler?
A priority control, typically an aquastat, tells the boiler when to direct output toward the tank's coil for recovery and when to hand priority back to space heating.